{{currentDevice.deviceID}}
You can also select one of these nearby devices:

The device ID to enter here can be found in the "Actions > Show ID" dialog on the other device. Spaces and dashes are optional (ignored). When adding a new device, keep in mind that this device must be added on the other side too. The device ID cannot be blank. The entered device ID does not look valid. It should be a 52 or 56 character string consisting of letters and numbers, with spaces and dashes being optional. A device with that ID is already added.

Shown instead of Device ID in the cluster status. Will be advertised to other devices as an optional default name.

Shown instead of Device ID in the cluster status. Will be updated to the name the device advertises if left empty.

Deselect folders to stop sharing with this device.  Select All  Deselect All

1 The remote device has not accepted sharing this folder.

2 The remote device has paused this folder.

Select additional folders to share with this device.  Select All  Deselect All

There are no folders to share with this device.

Enter comma separated ("tcp://ip:port", "tcp://host:port") addresses or "dynamic" to perform automatic discovery of the address.

Number of Connections   Help

The number of connections must be a non-negative number.

When set to more than one on both devices, Syncthing will attempt to establish multiple concurrent connections. If the values differ, the highest will be used. Set to zero to let Syncthing decide.

Incoming Rate Limit (KiB/s)

The rate limit must be a non-negative number (0: no limit)

Outgoing Rate Limit (KiB/s)

The rate limit must be a non-negative number (0: no limit)

The rate limit is applied to the accumulated traffic of all connections to this device.

All folders shared with this device must be protected by a password, such that all sent data is unreadable without the given password.